ST-Link V2 Compatible Programmer

Explore new microcontroller worlds with an ST-Link-Compatible Programmer & Emulator / Debugging dongle. This little USB stick contains a microcontroller with the code for ST’s classic programmer/emulator for STM8 and STM32 bit processors. Since STM’s are so common, this tool will come in handy whenever you encounter them. You can even get 5V and regulated 3.3V power!

Comes with one USB stick and a couple pieces of female-female jumpers.

Quick Spec

• 5 V power supplied by a USB connector
• USB 2.0 full speed compatible interface
• SWIM Specific Features
  • 1.65 V to 5.5 V application voltage supported on SWIM interface
  • SWIM low-speed and high-speed modes supported
  • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
  • SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector
  • SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
• JTAG Specific Features
  • 1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs
  • JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
  • JTAG support
  • SWD and serial wire viewer (SWV) communication support
• Direct firmware update feature supported (DFU)
• Status LED which blinks during communication with the PC
• Operating Temperature: 0 ~ 50°C
• Net Weight: 13g

Resources

• Additional Information

Shipping List

• 1 x ST-Link V2 Compatible Programmer
• 4 x Female-Female Jumper Wires